Cruise control

The vehicle can be driven at a set speed even if the accelerator pedal is not depressed.

Use the cruise control only on highways and expressways.

Warning:

For safe use

Driving safely is solely the responsibility of the driver. Therefore, do not overly rely on this system. The driver is solely responsible for paying attention to the vehicle’s surroundings and driving safely.

Set the speed appropriately according to the speed limit, traffic flow, road conditions, weather conditions, etc. The driver is responsible for confirming the set speed.

Situations in which cruise control should not be used

Do not use the cruise control in the following situations. As the system will not be able to provide appropriate control, using it may lead to an accident resulting in death or serious injury.

On roads with sharp bends

On winding roads

On slippery roads, such as those covered with rain, ice or snow

On steep downhills, or where there are sudden changes between sharp up and down gradientsVehicle speed may exceed the set speed when driving down a steep hill.

When it is necessary to disable the system: When it is necessary to disable the system

When towing another vehicle

TDA (Trailer Driving Assist)*

When lift up

System components

Multi-information display Cruise control

Display Cruise control Meter display

Set vehicle speed

Cruise control indicator

Switches Cruise control Switches

Driving assist switch

“ +” switch/“ RES” switch

Cancel switch

“ -” switch

Driving assist mode select switch

Using the cruise control

Setting the vehicle speed

Press the driving assist mode select switch to select Cruise Control Mode.

The cruise control indicator will illuminate.

Using the accelerator pedal, accelerate to the desired vehicle speed (approximately 20 mph [30 km/h] or more), and press the driving assist switch to set the set vehicle speed.

The vehicle speed at the moment the switch is released will be the set vehicle speed.

Adjusting the set vehicle speed

Adjusting the set vehicle speed using the switches

To change the set vehicle speed, press the “ +” or “ -” switch until the desired speed is displayed.

Increase set vehicle speed

Decrease set vehicle speed

The set vehicle speed will increase or decrease as follows:

Fine adjustment: By 1 mph (1.6 km/h) or 1 km/h (0.6 mph) each time the switch is pressed

Large adjustment: Increases continuously while the switch is pressed and held

Increasing the set vehicle speed using the accelerator pedal

Depress the accelerator pedal to accelerate the vehicle to the desired vehicle speed.

Press the “ +” switch.

Canceling/resuming control

Press the cancel switch or driving assist switch to cancel control.

Control will also be canceled if the brake pedal is depressed.

Press the “ RES” switch to resume control.

Note:

Automatic cancelation of the cruise control

In the following situations, the cruise control will be canceled automatically:

When the vehicle speed drops approximately 10 mph (16 km/h) or more below the set vehicle speed

When the vehicle speed drops below approximately 20 mph (30 km/h)

When the brake control or output restriction control of a driving support system operates (For example: PCS, drive-start control)

Vehicles with manual transmission: When the shift lever is in N or the clutch pedal is depressed for more than a certain amount of time

When the parking brake has been operated

When the driver’s seat belt is unfastened

Situations in which some or all of the functions of the system cannot operate: Situations in which some or all of the functions of the system cannot operate

Display and system operation state

The operating state of cruise control is indicated.


Indicator		Situation
White	Blank	Cruise control being OFF
Green	Set vehicle speed: Green	Constant speed cruising
Green	Set vehicle speed: Green in reverse display	Set vehicle speed being exceeded