Light bulbs You may replace the following bulb by yourself. If necessary bulb replacement seems difficult to perform, contact your Toyota dealer. For more information about replacing other lights, contact your Toyota dealer. Preparing for light bulb replacement Check the wattage of the light bulb to be replaced. (Light bulbs) Bulb location Front turn signal/parking lights (bulb type) Lights that need to be replaced by your Toyota dealer Headlights Daytime running lights Front turn signal/parking lights (LED type) Front fog lights (if equipped) Side marker lights Side turn signal lights Tail lights Stop lights Back-up light Rear turn signal lights High mounted stoplight/cargo lamp Trailer hitch light (if equipped) Bed lights (if equipped) License plate light Note: When replacing the light bulbs Confirm that they are properly engaged with the bulb base and that there is no light leakage. Turn signal lights Replacing light bulbs Tail lights Replacing light bulbs Stop lights Replacing light bulbs Side turn signal lights Replacing light bulbs Rear turn signal lights Replacing light bulbs Lights Replacing light bulbs License plate light Replacing light bulbs Headlights Replacing light bulbs Front turn signal/parking lights Replacing light bulbs Back-up lights Replacing light bulbs Fog light Replacing light bulbs Front fog light Replacing light bulbs High mounted stoplight Replacing light bulbs Cargo lamp Replacing light bulbs Trailer hitch light Replacing light bulbs Bed lamp Replacing light bulbs Trailering light Replacing light bulbs Side marker lights Replacing light bulbs Daytime running lights Replacing light bulbs LED Lights The lights other than front turn signal/parking lights (bulb type) consist of a number of LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to have the light replaced. Condensation build-up on the inside of the lens Temporary condensation build-up on the inside of the lens of any lights does not indicate a malfunction. Contact your Toyota dealer for more information in the following situations: Large drops of water have built up on the inside of the lens of any light. Water has built up inside of any lights. When replacing light bulbs When replacing light bulbs Front turn signal/parking lights Replacing light bulbs Replacing light bulb Front turn signal/parking lights (bulb type) Remove the 4 push clips and air cleaner inlet. (for passenger’s side only) Turn the bulb base counterclockwise. Remove the light bulb. Install a new light bulb and turn the bulb base clockwise. Install the air cleaner inlet and 4 push clips. (for passenger’s side only) Warning: Replacing light bulbs Turn off the lights. Do not attempt to replace the bulb immediately after turning off the lights. The bulbs become very hot and may cause burns. Do not touch the glass portion of the light bulb with bare hands.When it is unavoidable to hold the glass portion, use and hold with a clean dry cloth to avoid getting moisture and oils on the bulb. Also, if the bulb is scratched or dropped, it may blow out or crack. Fully install light bulbs and any parts used to secure them. Failure to do so may result in heat damage, fire, or water entering the light unit. This may damage the lights or cause condensation to build up on the lens. To prevent damage or fire Make sure bulbs are fully seated and locked.